made in the USA

How to Apply a Decal or Sticker

How To Apply A Small Sticker or Decal

  1. Clean the area thoroughly with rubbing alcohol or soap and water. Do not use Windex or similar products because it will leave a residue behind that will prevent the sticker from adhering well.
  2. Prepare the sticker for application by firmly rubbing a squeegee or credit card across the clear transfer tape. This removes any air bubbles that may have formed and makes the sticker cling to the transfer tape.
  3. Peel the white paper backing off the sticker. If the sticker clings to the backing, slowly replace the paper backing and repeat Step 2.
  4. Slowly lower the sticker onto the surface and rub it in place firmly with a squeegee or credit card. For best results, wait 24 hours before moving to the next step.
  5. Slowly peel the clear transfer tape off at an angle. Be careful not to pull the sticker off the surface. If sticker pulls away from the surface repeat Step 4.

*Use a pin to poke any air bubbles in the center and push the air out through the hole.
*For best results do not apply a sticker in extreme hot or cold temperatures.

How To Apply A Large Windshield Decal or Sticker

  1. Prepare the sticker for application by firmly rubbing a squeegee or credit card across the clear transfer tape. This removes any air bubbles that may have formed and makes the sticker cling to the transfer tape.
  2. Clean the area with rubbing alcohol or soap and water. Do not use Windex. Place the sticker in the desired location with a piece of masking tape on the top of the sticker to hold it in place. Cut into 3 parts between letters.
  3. Lift the sticker up and peel the white paper backing off the sticker. Be careful not to pull the masking tape off. Hold on to the bottom of the sticker.
  4. Slowly lower the sticker and rub it in place with a squeegee or credit card. Start at the top middle and then the outer edges. Firmly rub the sticker in place to make sure there is no air trapped under the sticker. Repeat for each part.
  5. For best results wait 24 hours then slowly peel the clear cover off at an angle. Be careful not to pull the sticker off the surface. If the sticker pulls away from the surface repeat step 4.

*Use a pin to poke any air bubbles in the center and push the air out through the hole.
*For best results do not apply a sticker in extreme hot or cold temperatures.